Fuji Electric NA0AX06-PT - Analog Output Unit (Type: NA0 AY02-MR)

2-17
Section 2 Specications
2-3-2 Analog output unit (Type: NA0AY02-MR)
(1) Names
The jumper pins in the analog output unit are used to change the analog signal range and digital value range. Therefore, remove
the upper cover and control board when setting the jumper pin.
NA0AY02-MR
3) JP1
5) JPA (CH1)
5) JPA (CH0)
4) JPB (CH0)
4) JPB (CH1)
2) Terminal block
1) Status indication LED
Nameplate
Expansion connector (IN)
Expansion connector (OUT)
2) Terminal block
Pin layout of control board
(When the upper cover is removed)
<Notes on mounting/removing the upper cover and control board>
• When handling the analog unit, remove it from the control panel, turn off the power, and disconnect other units.
• The procedure for handling the upper cover and printed circuit board, see “Appendix 1 Unit Handling Procedure.”
• Before mounting/removing the upper cover or handling the printed circuit board, be sure to eliminate static electricity.