Fuji Electric NA0AX06-PT - Page 27

2-18
Section 2 Specications
Status indication LED Status Specication
PWR of analog output unit ON (red) While 5V DC power is normally supplied.
(2) Functions
1) Status indication LED
2) Terminal block
These are terminals for 24V DC power supply to operate the analog unit and analog input signal.
* For the wiring method, see “2-4 Wiring.”
3) JP1: Digital value range selection
This jumper pin is used to set the digital value range.
4) JPA and JPB: Analog output range selection
B
U
B
U
U B
5V
10V
U B
5V
10
V
U B
5V
10V
U B
5V
10
V
U B
5V
10
V
U B
5V
10
V
U B
5V
10
V
U B
5V
10V
V
I
V
I
* When handling the setting pins on the printed circuit board, be sure to turn OFF the unit power. Securely mount them by using
tweezers.
Digital value range JP1 setting
-8192 to 8191
0 to 16383
Signal range JPA setting JPB setting
0 to 10V
-10 to 10V
0 to 5V
-5 to 5V
0 to 20mA
-20 to 20mA
0 to 10mA
-10 to 10mA