Fuji Electric NA0AX06-PT - Page 30

2-21
Section 2 Specications
6) JP3 and JP4: Analog input range selection
U
B
5V
10V
U
B
5V
10V
U
B
5V
10V
U
B
5V
10V
7) JP5 to 8: Input voltage/current selection
This jumper pin is used to select voltage or current for each channel.
I
V
I
V
* When handling the setting pins on the printed circuit board, be sure to turn OFF the unit power. Securely mount them by using
tweezers.
Signal range JP3 setting JP4 setting
0 to 10V
or
0 to 20mA
0 to 5V
or
0 to 10mA
-10 to 10V
or
-20 to 20mA
-5 to 5V
or
-10 to 10mA
Voltage/current
Setting of
JP5 (CH0) to JP8 (CH3)
Voltage
Current