Fuji Electric ZKJ Series - Page 50

6 - 10
(5) The cursor next to the range of the se-
OHFWHG&KFRPSRQHQWLVKLJKOLJKWHG
Select the range to be calibrated mainly
by pressing the
or the key.
(6) Then press the
ENT
key, and calibration is
performed in the selected range.
Operation by setting
Auto calibration is performed under the following rules.
1. Zero calibration is performed at the same time, for the Ch (component) with which “enable”
is selected at the time of auto calibration and auto zero calibration.
2. Span calibration is performed in the order from smallest Ch No., for the Ch (component)
with which “enable” is selected at the time of auto calibration.
ZERO calibration on auto calibration and auto zero calibration of the component with
which “enable” is selected are performed in batch irrespective of the description in
“6.2.2 Setting of manual zero calibration.”
CAUTION
Auto calibration and the manual calibration
of the component with which “AR” has
been selected as range switch mode are
performed in the range selected here. In this
case, once the calibration is started, the range
is automatically switched, and on completion
of the calibration, the original range is
resumed.
The range identification contact is inter-
locked with the range after the switch.
However, if the hold setting is set to “ON,”
the contact status before calibration is main-
tained.
To close "Auto Calibration
Component/range" setting
( )
ENT
 3UHVVWKH key in the state described in
(5), and the highlight is switched between
³HQDEOH´DQG³GLVDEOH´DXWRFDOLEUDWLRQ
6HOHFW³HQDEOH´RI³GLVDEOH´E\SUHVVLQJ
the
or the key.
7KHQSUHVVWKH
ENT
key.
Press the key to exit automatic calibra-
tion component/range setting, and the pre-
vious screen appears.
To close the setting
ESC
( )
ENT
End of Auto Calibtation
Range Setting
End of Auto Calibtation
component setting
0
0
0 0
0
0
0
Cal. Sett i ngs Select a range for
Auto Cal.
auto calibration
Ch1
~Range 1 0-100
ppm
enable
NOx
Ranqe2 0-2000 ppm
Ch2
• Range 1 0-100
ppm
enable
S02
Ranqe2 0-2000 oom
Ch3
• Range 1 0-10
1,101 %
enable
CO2
Ranqe2 0-20
1,101 %
Ch4
• Range 1 0-100
ppm
enable
co
Ranqe2 0-2000 oom
Ch5
Rangel 0-10
1,101 %
enable
02
• Ranqe2 0-25
1,101 %
II II
Cal. Sett i ngs
Set enable or disable
Auto Cal.
for auto cal i brat ion
~ Ch1
Range 1 0-100
ppm
n!IE
NOx
Ranqe2 0-2000 ppm
Ch2
Range 1 0-100
ppm
enable
S02
Ranqe2 0-2000 ppm
Ch3 Rangel 0-10 vol%
enable
CO2
Ranqe2 0-20
1,101 %
Ch4 Range 1 0-100
ppm
enable
co
Ranqe2 0-2000 ppm
Ch5
Rangel 0-10
1,101 %
enable
02
Ranqe2 0-25
1,101 %
II II