Fuji Electric ZKJ Series - Page 73

6 - 33
Reset input
So long as close, resetting lasts.
At the edge of changing from closing to opening, the average action restarts.
Close (hold at least 1.5 sec.)
Open
Average value reset
This mode is used to clear O
2
average values and O
2
conversion average values and restarts aver-
aging. All average values are reset at a time. The indication value and output value is 0 ppm,
YRORUVRDWWKHWLPHRIWKHUHVHWLQSXW5HIHUWRWKHDYHUDJHSHULSG
Average period
It allows you to set an average period of the
average value of O
2
conversion and O
2
average.
,WHQDEOHV\RXWRVHWDQDYHUDJHWLPHRIWR
minutes (1-minute step) or 1 to 4 hours (1-hour
step).
 &KDQJLQJWKHVHWWLQJUHVHWVWKHDYHUDJHYDOXH
of O
2
conversion and O
2
average value. (Press-
ing the
ENT
validates the resetting only for
components whose setting was changed.)
Response time
The response time of the electrical system can
be changed.
Setting is available by components.
Note) It does not provide exact seconds for
the setting time, but it gives a guide
of the setting time.
 7KHVHWWLQJYDOXHFDQEHPRGL¿HGDV
requested by the customer.
~----~-------------------------
Parameter Select Ch No.
Response Time
~ Chl NOx 10 sec
Ch2
SO2 20 sec
Ch3 CO2 15 sec.
Ch4
co
12 sec.
Ch5
02
22 sec.
Parameter Select Ch No
Average Period
~ Ch9 ~NOx
01 hour
Chl0
~SO2
01 hour
Chll
36CO2
01 hour
0
Ch12
IW. 02
01 hour