Fax/Internet Fax
225
Fax
4
1
Specify a line (port) using the drop down menu.
This feature is also available when you specify a recipient registered in the Address Book.
Select a line, and then specify a recipient using the one touch button, speed dial, or address
book.
Even if the selected fax number of a recipient includes letters specifying a line, the machine
puts a high priority on the line selected by this feature.
When the fax number of a recipient (<1>0123456789) selected from the Address Book
specifies line 1, and you also select line 2 from the drop down menu.
Display example: <2><1>0123456789
In this case, the machine puts a high priority on <2> (line 2) selected from the drop down
menu.
Note •
When you use this feature with registered numbers in the Address Book, select [Yes] in [Chain Dial]
under [Tools] > [System Settings] [Fax Service Settings] > [Fax Control].
Entering Specific Symbols
When specifying a recipient, you can use the following features to enter specific symbols on
the touch screen.
Feature Button Function Input method
Enter pause - or
<Pause> (-)
Used to enter a pause.
One pause is 3 seconds.
You can enter pauses of 6
seconds, 9 seconds, etc.
with additional button
presses.
Press the <Pause> button.
(Example)
0-123 ...
0--123 ...
Transmit using a
password
S When a password has
been set, transmission will
start only if the password
matches the ID number
on the remote terminal.
1. Select [ ] on the
[Fax/Internet Fax]
screen to display the
keyboard.
2. Select [S].
(Example)
0312345678S12345678
Transmit DTMF
signal
! Used to transmit the
DTMF signal.
1. Select [ ] on the
[Fax/Internet Fax]
screen to display the
keyboard.
2. Select [More
Characters].
3. Select [!].
(Example)
0311123456!123#
To Next Page
Loading...
