Calling a Stored Program
399
Stored Programming
8
Calling a Stored Program for Build Job
You can call a stored program for Build Job on the [Copy] screen displayed while Build Job
is running.
1
Select [Change Settings].
2
Select the [Job Assembly] tab.
3
Select [Stored Programming].
4
Select a number of a stored program containing the features you want to use.
Note • You can only select registered numbers.
• After the stored program has been called, the machine sounds an audible tone. If a failure occurs,
the machine sounds a fault tone.
For information on how to change the volume of the sound that notifies that a stored program has been called, refer to "5
Tools" > "Common Service Settings" > "Audio Tones" > "Stored Programming Complete Tone" in the Administrator Guide.
To Next Page
Loading...
