3 Maintenance
100
Maintenance
3
Executing 2 Sided Color Scanning Calibration
This section describes the procedures to adjust scan colors for side 1 and side 2 of the duplex
automatic document feeder.
Important • For the correct output result, execute the calibration in advance. For the calibration, refer to
"Executing Calibration" (P.96).
1 Press the <Log In/Out> button.
2 Enter the system administrator’s user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator’s passcode,
and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3 Select [Tools] on the Services Home screen.
Note • When the Services Home screen is not
displayed on the touch screen, press the
<Services Home> button.
4 Select [System Settings] > [Common Service
Settings] > [Image Quality Adjustment].
5 Select [2 Sided Color Scanning Calibration].
6 Select [Paper Supply] and set the paper tray. Select [Print Chart] and then [Start].
Note • Selecting [Restore Previous Values] and then [Start] restores the previous settings. To restore factory
default settings, select [Restore Factory Default Values] and then [Start]. In both cases, a message is
displayed on the touch screen when the restoration completes.
To Next Page
Loading...
Need help?
General
