Using the Operator Panel Menus 170
• Host Access List
Purpose:
To control the access from the specified IP addresses. The change becomes effective after the printer
is turned off and then on.
Values:
• Reset Defaults
Purpose:
To initialize wired network data stored in Non-Volatile Memory (NVM). After executing this function and
rebooting the printer, all wired network settings are reset to their default values.
• Wireless LAN (DocuPrint CP205 w Only)
Purpose:
To enable the wireless connection.
Values:
Port9100 Disable Disables the Port9100 port.
Enable* Enables the Port9100 port.
WSD Disable Disables the WSD port.
Enable* Enables the WSD port.
SNMP Disable Disables the Simple Network Management Protocol (SNMP)
UDP port.
Enable* Enables the SNMP UDP port.
Email Alerts Disable Disables the Email Alerts feature.
Enable* Enables the Email Alerts feature.
InternetServices Disable Disables an access to CentreWare Internet Services
embedded in the printer.
Enable* Enables an access to CentreWare Internet Services
embedded in the printer.
Bonjour (mDNS) Disable Disables the Bonjour (mDNS).
Enable* Enables the Bonjour (mDNS).
No.1-5/Address Specifies the IP address which you want to control the access to your printer.
No.1-5/Mask Sets the subnet mask for the specified IP address.
No.1-5/Mode OFF* Selects whether to accept or reject the access from the
specified IP address.
Accept
Reject
Enable* Enables the wireless connection.
Disable Disables the wireless connection.
To Next Page
Loading...
