Network Basics 76
• Ethernet Cable
1 Select Ethernet Cable, and then click Next.
2 Follow the instructions, and then click Next.
The Printer Setup Utility screen appears.
3 Select the printer to be configured in the Select Printer screen, and then click Next.
NOTE:
• If the printer to be configured is not listed in the Select Printer screen, try the following steps:
- Click Refresh to update the information.
- Click Enter IP Address, and then enter the IP address of your printer.
4 Enter the SSID.
5 Select Type of wireless network.
6 Configure the security setting, and then click Next.
The IP Address Settings screen appears.
7 Select IP Mode depending on your network scheme.
When IPv4 is selected:
• Configure the following:
a Select Type.
b Enter the following items:
• IP Address of your printer
• Network Mask
To Next Page
Loading...
