To Next PageTo Next PageWhat to do if the FujiFilm Printer film cover won't eject?
If the film cover of your FujiFilm printer cannot be ejected, it might be because the printer cannot recognize the film pack. Remove the film pack and load it again to resolve this.
Why won't the film eject completely from my FujiFilm Printer?
If the film of your FujiFilm printer cannot be ejected to the end, it could be due to the printer shaking or being dropped, causing the film to misalign. Try grasping the edge of the film and pulling it out. Alternatively, performing another printing operation may push the jammed film out.
What to do if the FujiFilm instax SHARE SP-3 film pack won't eject?
If the film pack cannot be ejected from your FujiFilm printer, it might be because the printer shook or was dropped, misaligning the film, or the film has jammed. Try loading a new film pack. If that doesn't work, remove the battery and insert it again. If the problem persists, remove the jammed film and then load a new film pack.
General| Power source | Battery |
|---|---|
| Charging time | 3 h |
| Power consumption (printing) | 3 W |
| Print technology | - |
| Maximum resolution | 800 x 600 DPI |
| Time to first page (color, normal) | 13 s |
| Certification | CE |
| Product color | Black |
| Printing colors | Blue, Green, Red |
| Built-in display | No |
| Grayscale levels | 256 |
| Market positioning | Home & office |
| Operating temperature (T-T) | 5 - 40 °C |
| Total output capacity | 160 sheets |
| Maximum input capacity | 10 sheets |
| Maximum print size | 2.4\ |
| USB port | Yes |
| USB connector | Micro-USB Type-A |
| USB 2.0 ports quantity | 1 |
Weight and Dimensions| Depth | 130.5 mm |
|---|---|
| Width | 116 mm |
| Height | 44.4 mm |
| Weight | 312 g |
Instructions on how to insert the printer battery.
Initial steps to connect the printer to a device.
Troubleshooting common printing problems.
General advice and precautions for printer maintenance.
