82
1
Select F FLASH SETTING
in the shooting menu and,
after con rming that ON is
selected for Built-In Flash,
select FLASH FUNCTION
SETTING to display ash op-
tions.
EXIT
FLASH SETTING
RED EYE REMOVAL
TTL-LOCK MODE
FLASH FUNCTION SETTING
LED LIGHT SETTING
MASTER SETTING
CH SETTING
Built-In Flash
ON
Q Choosing OFF for Built-In
Flash disables the built-in
ash.
FLASH SETTING
RED EYE REMOVAL
TTL-LOCK MODE
FLASH FUNCTION SETTING
LED LIGHT SETTING
MASTER SETTING
CH SETTING
Built-In Flash
ON
OFF
2
Highlight items using the
selector and rotate the rear
command dial to change
the highlighted setting.
MODE
Built-In Flash
3
Press DISP/BACK to put the changes into e ect.
Q The ash will not re at some settings, for example
in panorama mode or when the electronic shutter
is used.
Q Choose shutter speeds slower than
/
when using
the ash in exposure mode S (shutter-priority AE) or
manual (M).
R The ash will not re if OFF is selected for SOUND&
FLASH in the D USER SETTING menu.
R In TTL mode, the ash may re several times with
each shot. Do not move the camera until shooting
is complete.
R Optional lens hoods are not recommended for use
with the built-in ash as they may cast shadows that
cause vignetting.
Red-Eye Removal
Red-eye removal is available when an option other than
OFF is selected for F FLASH SETTING> RED EYE REMOV-
AL and G AF/MF SETTING> FACE/EYE DETECTION SET-
TING is ON. Red-eye removal minimizes “red-eye” caused
when light from the ash is re ected from the subject’s
retinas.
Flash Sync Speed
The ash will synchronize with the shutter at shutter
speeds of
/
s or slower.
Optional Flash Units
The camera can be used with optional FUJIFILM
shoe-mounted ash units (P 141). Do not use third-
party ash units that apply over 300 V to the camera
hot shoe.
Flash Photography
Use the built-in ash for additional lighting when shooting at night or indoors under low light.
To Next Page
