2
■ Indications on the Function
Number Display
The following shows the indications on the Function
Number Display.
No. Descriptions
8
Lights only one time upon turning on the scanner.
P
Indicates that the scanner has been turned ON and
is being initialized.
0
Indicates that initialization will soon be com-
pleted.
1
Indicates that initialization has been completed
successfully.
This status is called "Ready Status".
U
Indicates that a temporary error (that users can
solve) has occurred during the initialization or
scanning of documents.
"U" and an error number (0, 1, 9) are displayed
alternately. Refer section "Temporary error" on
page. AP-3.
To return the scanner to the ready status ("1"),
press the "Scan" or "Send to" button while the
error is indicated. Refer section "Temporary error"
on page. AP-3.
E
Indicates that a device alarm (that users can not
solve) has occurred during the initialization or
scanning of documents.
"E" and an alarm number (0, 2 ,7, b, c, d) are indi-
cated alternately.
To return the scanner to the ready status ("1"),
press "Scan" or "Send to" button.
If this alarm occurs, turn the power off and then on
again. If the alarm is indicated after turning on the
power again, contact your service engineer.
To Next Page
Loading...
Need help?
General