10. THERMISTORS removal
11. SOLENOID COILS (4way valve and Solenoid valves) removal
Cut the binder.
Remove the mounting screw. Remove the SOLENOID COIL.
Remove the PRESSURE SENSOR
with wrench.
There are two sensors.
(High and Low pressure)
Remove the heat insulation.
06-07
13. PRESSURE SENSORS removal
12. EEV COILS removal
Remove the EEV coil by hand.
There are two coils.
Note the tightening torque at the installation.
Tightening torque is 15 1.5N m.
To Next Page
Loading...
