Fujitsu AOU36RLXFZH - Function Settings; 13-1.Indoor Unit (Setting by Jumper Wire)

- 128 -
MULTI TYPE 4 rooms type
13. Function settings
To adjust the functions of this product according to the installation environment, various types of
function settings are available.
NOTE: Incorrect settings can cause a product malfunction.
13-1. Indoor unit (setting by jumper wire)
NOTE: This setting is necessary only for slim duct type.
 Component location
 Jumper wire setting
 Drainage function setting (JM1)
 Auto louver grille setting (JM2)
When optional Auto louver grille kit is attached, set this setting to "Valid".
 Fan delay setting (JM3)
JM1 Function Factory setting
Connect Enable ♦
Disconnect Disable
JM2 Function Factory setting
Connect Disable ♦
Disconnect Enable
JM3 Function Factory setting
Connect Disable ♦
Disconnect Enable
JM1
JM2
JM3