- 143 -
MULTI TYPE
4 rooms type
UTY-RNNUM
Button name and function
During address setting mode, indoor unit reject the any operation command from remote controller.
Function setting procedure
1. Connect the power supply of the outdoor unit.
2. Switch to the function setting mode.
To enter the function setting mode, hold down the 3 buttons of SET TEMP. , SET TEMP. , and
FAN at the same time for 5 seconds or longer.
3. Select the function number by pressing the SET TIME < or the SET TIME > button.
4. Select the setting number by pressing the SET TEMP. or the SET TEMP. button.
The display flashes during setting number selection.
Function number
Refer to Function details
Remote controller address
SET TIME “<” and “>” button
Switches the function number.
Setting number
Refer to Function details
SET TEMP. “V” and “
Λ
” button
Switches the setting number.
TIMER SET button
Transmits function setting
To Next Page
Loading...
