- 147 -
MULTI TYPE
4 rooms type
4. Select the setting number by pressing the SET TEMP. or SET TEMP. button.
The setting number indicator flashes during setting number selection.
5. Confirm the setting by pressing the TIMER SET button.
The data will be transferred to the indoor unit.
Function details: Refer to Chapter 13-5. "Function details" on page 149.
6. Exit the function setting mode by pressing the 3 buttons of SET TEMP. , SET TEMP. ,
and FAN at the same time for 5 seconds or longer.
After exiting the function setting mode, the display returns to the normal mode.
If no button is pressed within 60 seconds after buttons mentioned above are pressed, it will auto-
matically exit the function setting mode.
If you exit the function setting mode unintentionally during setting, enter the mode again according
to the procedure in step 2.
Example) Function number : 30, Setting number : 01
Setting number
Not good
Data is correctly set up on
the indoor unit.
● Data is not set up on the indoor unit
correctly (-- is displayed.)
● Set up the data again according to the
procedure in step 3, 4 above.
Normal mode display
To Next Page
Loading...
