- 41 -
MULTI TYPE
4 rooms type
Installation
1. Remove the insulation of the remote controller cable.
2. Insert the flat-blade screwdriver and remove the front case and rear case by twisting it slightly.
3. Install the rear case to the wall, box, etc. with 2 screws (M4 × 16 mm). Fix the 2 screws in
either horizontal or vertical position.
A. When mounting on the box:
Attach the case after leading the cable.
B. When the cable is along the wall:
• Mount the rear case on the wall.
• Remove knock out hole for cable routing in the front case.
When connecting the remote controller cable, take measures to prevent the water or insects
coming into the remote controller through the cable, such as to provide the trap or close the
hole for cabling with the putty.
4. Configure the DIP switch setting with referring Chapter 13-8. "Central remote controller" on
page 157.
5/16
(
8
)
5/16 (8)
5/16 (8)
1-3/16 (30)
1-3/4 (45)
2-3/16 (55)
1. 12V (Red)
2. Signal (White)
3. COM (Black)
Unit: in (mm)
Flat screwdriver
Front case
Hooks (2 places)
Rear case
Screws
Box
Remote controller cable
Rear case
Putty
Putty
Putty
Trap
Trap
Trap
To Next Page
Loading...
