6. SYSTEM DESIGN
Fix the unit (When hanging from the ceiling)
CAUTION
Do not hang from the ceiling when performing a vertical installation. ●
(1) Secure the hangers (accessories) with the screws (2 pieces, Ø 4 x 10mm, accessories). (4 places)
Screw
Hanger (4 places)
(2) Secure the attachment section with the hanging bolt. (Use M8 or M10 for the hanging bolt)
(3) Secure the hangers with hexagonal nuts (field supply) and the washers (accessories) as shown in
the figure below.
(4) Once you have checked the unit is flat, fasten the hexagonal nuts.
(The unit’s slope must be within ±5° in all directions.)
(20 to 30)
25/32 to 1-3/16
Hanging bolt (M8 or M10)
Unit: in. (mm)
Hexagonal nuts
(M8 or M10)
Washers
- (06 - 33) -
SYSTEM
DESIGN
SYSTEM
DESIGN
To Next Page
Loading...
