6. SYSTEM DESIGN
INDOOR UNIT (setting by simple remote controller)5-5.
This procedure changes to the function settings used to control the indoor unit according to
●
the installation conditions. Incorrect settings can cause the indoor unit malfunction.
After the power is turned on, perform the “FUNCTION SETTING” according to the
●
installation conditions using the remote controller.
The settings may be selected between the following two: Function Number or Setting
●
Number.
Settings will not be changed if invalid numbers or setting numbers are selected.
●
PREPARATION
(1) Turn on the power to the Branch box.
By turning on the power indoor units, so make sure the piping air-tight test and vacuuming have been conducted ●
before turning on the power.
Also check again to make sure no wiring mistakes were made before turning on the power. ●
Indoor
units
Branch box
Breaker ON
- (06 - 64) -
SYSTEM
DESIGN
SYSTEM
DESIGN
To Next Page
Loading...
