6. SYSTEM DESIGN
FUNCTION SETTING
3) Press the FAN button so that the “Function number” display flashes. Then, press either the
SET TEMP.
button or the SET TEMP.
button to set up the function number.
Function number
4) Press the FAN button so that the “Setting number” display flashes. Then, press either the
SET TEMP.
button or the SET TEMP.
button to set up the setting number.
Ex.) Function number : 30, Setting number : 01
Setting number
5) Pressing the START/STOP button, confirm the setting.
(The data will be transferred to the indoor unit.)
NOT GOOD
When the data was normally set up on the indoor
unit.
When the data was not set up on the indoor ●
unit (-- is displayed.)
Set up the data again according to the ●
procedure in step 3), 4) above.
GOOD
FUNCTION DETAILS
Refer to 5-6. FUNCTION DETAILS
- (06 - 66) -
SYSTEM
DESIGN
SYSTEM
DESIGN
To Next Page
Loading...
