6. SYSTEM DESIGN
PIPING INSULATION
(1) Install the coupler heat insulation (large and small) and insulation (long and short) on each pipe as
shown in the figures below.
(2) Attach the butting surface with no gap to eliminate any gap between the insulations.
(3) During the pipe insulation work, prevent air from getting inside the insulation with an adhesive tape
(field supply).
Indoor unit side
Coupler heat insulation (large)
Adhesive tape (field supply)
Adhesive tape (field supply)
Adhesive tape (field supply)
Insulation (long)
Coupler heat insulation (small)
Butting surfaces
Outdoor unit side
Coupler heat insulation (small)
Coupler heat insulation (large)
Butting surfaces
[First piece]
Insulation (short)
Insulation (short)
[Second piece]
Insulation (short)
Adhesive tape
(field supply)
Insulation (short) x 2
(cover with 2 pieces of
insulation)
NON-CONNECTING PIPES
(1) Install the coupler heat insulation (large and small) and insulation (long) as shown in the figure on
the right.
(2) Apply an adhesive tape (field supply) to prevent air from getting inside the insulation.
Insulation (long)
Adhesive tape (field supply)
Adhesive tape (field supply)
- (06 - 36) -
SYSTEM
DESIGN
SYSTEM
DESIGN
To Next Page
Loading...
