6. SYSTEM DESIGN
SWITCHING SELECTION OF FUNCTION SETTING MODE
(2) Press and hold the “FAN” and the “ SET TEMP.
”
䚷
buttons. While holding these 2 buttons,
press the "RESET" button.
SET TEMP. ( )
RESET
FAN
Function setting
mode display
SELECTION AND CONFIRMATION OF CUSTOM CODE
(3) Press the “ SET TEMP.
” or “ SET
TEMP.
” buttons to select the custom
code that matches the setting with the
indoor unit.By selecting the appropriate
custom code, the communication between
the indoor unit and the wireless RC
become possible.
CUSTOM CODE
(
--
-
)
The initial setting is " "
(4) Press the “TIMER MODE" button to send
the code to the indoor unit.
Pi Pi
Correct code:
Wrong code:
No Response
- (06 - 56) -
SYSTEM
DESIGN
SYSTEM
DESIGN
To Next Page
Loading...
