Fujitsu AOYG45LAT8 User Manual

The maximum value of the indoor fan speed is set as shown in Fig 10, based on the detected
temperature by the indoor heat exchanger sensor in heating mode.
< ASYG type >
01-10
5. HEATING OPERATION
Switch the airflow [Auto], and the indoor fan motor will run according to a room temperature,
as shown in Fig 10.
On the other hand, if switched in [Hi] [Quiet], the indoor motor will run at a constant airflow
of [Heat] operation modes Quiet, Lo, Me, Hi, as shown in Table 4.
6. COOL AIR PREVENTION CONTROL (For Heating and Min. Heat operation)
( Fig.10 : Airflow change - over ( Heating : Auto ) )
TR-Ts > -1.5°C
=
-2.5°C > TR-Ts
-1.5°C > TR-Ts > -2.5°C
=
TR-Ts > -1°C
=
-2°C > TR-Ts
-1°C > TR-Ts > -2°C
=
When the room
temperature rises
When the room
temperature drops
TR : Room temperature
Ts : Setting temperature
Lo
Me
Me+
42°C
30°C
34°C
When Indoor
heat exchanger
temperature rises
When Indoor
heat exchanger
temperature drops
Hi
*Me+ or setting
FAN mode
Cool air
prevention
39°C
37°C
37°C
32°C
28°C
S-Lo
*Lo or setting
FAN mode
29°C
When Indoor
heat exchanger
temperature rises
When Indoor
heat exchanger
temperature drops
*Lo or setting
FAN mode
37°C
32°C
24°C
*Hi or setting
FAN mode
S-Lo
During NORMAL HEATING OPERATION
< ARYG type >
*Lower speed is selected
Field setting is necessary at AR and AU type as "Cool air prevention : effective"
TR-Ts > -1.5°C
=
-2.5°C > TR-Ts
-1.5°C> TR-Ts > -2.5°C
=
TR-Ts > -1°C
=
-2°C > TR-Ts
-1°C > TR-Ts > -2°C
=
When the room
temperature rises
When the room
temperature drops
Lo
Me
Hi
< AUYG / ARYG / ABYG / AGYG type >
< ASYG type >
( Fig.11 : Airflow change - over for cool air prevention)
*Lower speed is selected

Fujitsu AOYG45LAT8 Specifications

General

Brand	Fujitsu
Model	AOYG45LAT8
Category	Air Conditioner
Language	English