Fujitsu AOYG45LAT8 User Manual

01-32
1-15. FORCED COOLING OPERATION
Forced cooling operation is started when pressing MANUAL AUTO button for 10 seconds or more.
During the forced cooling operation, it operates regardless of room temperature sensor.
Operation LED and timer LED blink during the forced cooling operation. They blink for 1 second ON
and 1 second OFF on both operation LED and timer LED (same as test operation).
Forced cooling operation is released after 60 minutes of starting operation.
FORCED COOLING OPERATION will start as shown in Table12.
OPERATION MODE
FAN CONT. MODE
TIMER MODE
SETTING TEMP.
SETTING LOUVER
SWING
( Table 13 : Detail of forced cooling operation)
Forced cooling operation
Cooling
Hi
Horizontal
OFF
Room temperature is not controlled
-
1-16. COMPRESSOR PREHEATING
1-17. 10°C HEAT OPERATION
MINIMUM HEAT OPERATION functions by pressing MIN HEAT button on the remote controller.
It is almost the same operation as below settings.
Operation mode
Setting temperature
Defrost operation
Oil recovery operation
Fan mode
Louver setting
Swing setting
LED indication
ON / OFF timer
( Table 15 : Detail of MINIMUM HEAT OPERATION )
Heating
10°C
Normal operation
Normal operation
Only ECONOMY LED (Green)
Start condition
Release condition
Outdoor temperature 32°C
and
30 minutes after the compressor stop
Judgment condition Operation
Crankcase heater : ON
Crankcase heater : OFF
Outdoor temperature 34°C
or
Operating instruction to outdoor unit
>
=
>
=
The compressor temperature is maintained more than ambient temperature (other refrigerant cycle parts)
for the following reasons.
1.To Prevent the compressor damage by the cold start.
2.Speed up the ascent rate of the refrigerant, and the separation of the refrigerant and oil is furthered.
( Table 14 : Detail of compressor preheating operation )

Fujitsu AOYG45LAT8 Specifications

General

Brand	Fujitsu
Model	AOYG45LAT8
Category	Air Conditioner
Language	English