En-27
11
5-6. Room temp. display setting
1
In “Submenu” screen, select [Room temp. display] with
the [Cursor button (Up/Down)], and press the [Enter
button].
Note
Displayed room temperature is the approximate tem-
perature detected around this remote controller, and it
could be different from the actual room temperature. It
alsobeinuencedbytheinstallationenvironmentofthe
remote controller.
5-7. Key lock select setting
A locking function is provided to prevent careless operation by
children or outsiders. Release the lock on the “Monitor” screen
when operating.
To lock up:
When the [Cancel button] is pressed for about 3 seconds or
more continuously on the “Monitor” screen
.
To release the lock:
When the [Cancel button] is pressed for about 3 seconds or
more continuously on the “Monitor” screen, the lock is re-
leased, and each applicable lock name on the screen turns
off.
5-5. R.C. sensor control setting
Note
This function can be used only if the setting is activated
in the installation. To activate this function, consult au-
thorized service personnel.
1
In “Submenu” screen, select [R.C. sensor control] with
the [Cursor button (Up/Down)], and press the [Enter
button].
When you set this setting to [On], the icon is displayed on the
“Monitor” screen.
To check the function, press the [Enter button] and select the
icon with the [Cursor button (Left/Right)].
To Next Page
Loading...
Need help?
General
