Fujitsu ARTG54LHTC - Troubleshooting; 8-1. General Troubleshooting

- (01 - 31) -
DUCT TYPE ARTG54LHTC DUCT TYPE ARTG54LHTC
5) Select the [Function No.] with pressing the [Cursor button
(Left/Right)], and select the Function No. to be set with
pressing the [Cursor button (Up/Down)].
C ancel : OK:
Function setting
Mo 10:00
R.C. Function Setting
address No. No.
Version Error history
00 00 00
6) Select the [Setting No.] with pressing the [Cursor button
(Left/Right)], and select the Setting No. to be set with
pressing the [Cursor button (Up/Down)],and press the
[Enter button].
C ancel : OK:
Function setting
Mo 10:00
R.C. Function Setting
address No. No.
Version Error history
00 00 00
!
CAUTION
• After turning off the power, wait 30 seconds or more before turning on it again. The Function Setting will not become active
unless the power is turned off then on again.