Fujitsu ARTG54LHTC - FUNCTION SETTING METHOD (for AR-WAF1 E (Option: UTY-RNNYN))

- (01 - 32) -
DUCT TYPE ARTG54LHTC DUCT TYPE ARTG54LHTC
FUNCTION SETTING METHOD 12-2-2.
(for AR-WAF1E (Option: UTY-RNNYN))
Setting method
z
(1) Press the set temperature buttons ( ) ( ) and fan control button simultaneously for more than 5 seconds to enter the function
setting mode.
SU
MO
TU WE
TH FR
SA
(2) Press the SET BACK button to select the indoor unit number.
SET BACK
SU
MO
TU
WE
TH FR
SA
Unit number of INDOOR UNIT
(3) Press the set time buttons to select the function number.
Function number
SU
MO
TU WE TH FR
SA
(4) Press the set temperature buttons ( ) ( ) to select the setting value. The display ashes as shown to the right during setting value
selection.
(5) Press the TIMER SET button to conrm the setting. Press the TIMER SET button for a few seconds until the setting value stops
ashing. If the setting value display changes or if “- -” is displayed when the ashing stops, the setting value has not been set correctly.
(An invalid setting value may have been selected for the indoor unit.)
Setting value
SU
MO
TU
WE
TH FR SA
(6) Repeat steps 2 to 5 to perform additional settings. Press the set temperature buttons ( ) ( ) and fan control button simultaneously
again for more than 5 seconds to cancel the function setting mode. In addition, the function setting mode will be automatically canceled
after 1 minute if no operation is performed.
(7) After completing the FUNCTION SETTING, be sure to turn off the power and turn it on again.
!
CAUTION
• After turning off the power, wait 30 seconds or more before turning on it again. The FUNCTION SETTING doesn’t become
effective if it doesn’t do so.