6. SYSTEM DESIGN
FUNCTION SETTING
3) Press the "Set Time <" button or the "Set Time >" button, to select the function number.
Function number
4) Press the "SET TEMP. V" button or the "SET TEMP. button, to select the setting number.
he dispa ashes during setting nuber seection.
Ex.) Function number : 30, Setting number : 01
Setting number
Press the button conr the setting.
(The data will be transferred to the indoor unit.)
GOOD
ERROR
When the data was not set up on the indoor
unit "--" is displayed.
Set up the data again according to the
procedure in step 3), 4) above.
When the data was correctly set up on the indoor
unit.
(Flashing display changes to illuminated display.)
FUNCTION DETAILS
Refer to 5-6. FUNCTION DETAILS
- (06 - 75) -
SYSTEM
DESIGN
SYSTEM
DESIGN
To Next Page
Loading...
