9. Send the function mode information by pressing the TIMER MODE button once.
10. Send the function setting information by pressing the START/STOP button once.
2 short beeps will be emitted from the indoor unit when the signal is received correctly. If wrong
code is set, no beep sound will be emitted.
NOTE: Press START/STOP button within 30 seconds after pressing TIMER MODE button.
Function details: Refer to Chapter 14-5. "Function details" on page 149.
11. Exit the function setting mode by pressing the RESET button.
To set custom code , , or , perform same procedures for each code.
Setting up each indoor unit
Repeat step from 1. to 11. to set up each indoor unit. If the custom code is other than " ", steps from
1. to 4. and 11. need to be performed.
- 132 -
14-2. Indoor unit (setting by wireless remote controller) 14. Function settings
MULTI TYPE
2, 3, 4 ROOMS TYPE
MULTI TYPE
2, 3, 4 ROOMS TYPE
To Next Page
Loading...
