Operation
OSD menu functions
The OSD menu fo r analogue monitor operation is described below. Du ring
digital operation some functions are not available, they are not needed because
of the digital transmission technology being u sed.
Adjusting the brightness and contrast
Call up the Brightness/Con
trast setting window
Brightness
Set the brightness o f th e display
With this function you change the b rightness of the background lighting.
Contrast
Set the contrast of the di
splay
With this func tion you m
odify the contrast of bright colour tones.
Black level
Set the brightness o f th e display
With this function you modify the contrast of dark colour tones.
Auto level
Adjust the signal level
With this function you can automatically set the contrast.
The function is executed with the
button.
If the contrast is set too high, bright surfaces can no longer be distinguished from very
bright surfaces. If the contrast is set too low, the m aximu m brightness will not be achieved.
Adjusting th
e picture size and position
Call the Image adjust setting window
Phase
Eliminate picture disturbance
With this function you fine-tune your monitor to eliminate picture disturbance.
Clock
Set synchronisation
With this function you adjust the picture width to eliminate vertical picture
disturbances.
H-Position
Adjust the horizontal position
With this function you move the picture to the left or to the right.
V-Position
Adjust the vertical position
With this function you m ove the picture up or down.
Expansion
Adjust the picture size
Full screen = selection of full screen mode
Keep aspect = maximum picture size without distortion
26 Fujitsu Technology Solutions
To Next Page
Loading...
Need help?
General