Modular RAID Controllers
73
Modular RAID 6Gb/s (SAS2.0)
4.6.4 Installation
This section describes how to install the SAS RAID controller in a server.
V CAUTION!
To safeguard against data loss, remember to back up your data before
you change your system configuration.
To install the new controller, proceed as follows:
Step 1 Unpack the controller
Unpack the new controller in a static-free environment. Remove
it from the anti-static bag and inspect it for damage.
If the controller appears to be damaged, contact the Fujitsu
support service.
Step 2 Prepare the server
Shut down and power off the server and remove the server blade
from the chassis.
Step 3 Install the new SAS RAID controller
Refer to the server blade specific Options Guide or Upgrade and
Maintenance Manual.
Step 4 Power-up the server
Replace the server cover and reinstall the server blade to the
chassis. Start up the server. Ensure that the SAS and/or SATA II
devices are properly connected to the controller.
During booting, a message similar to the following is displayed:
LSI MegaRAID SAS-MFI BIOS Version NTxx (Build
..date..)
Copyright(c) 2010, LSI Logic Corporation
HA-x (Bus x Dev y) PY SAS RAID HDD Module w/o Cache
(D2837)
FW package: xxxx
To Next Page
Loading...
Need help?
General
