Getting started
3
4
3x
► Remove the three screws at the bottom
of the foot (3) and separate the foot
from the hinge (4).
6 5
3x
► Remove the three screws at the hinge
(5) and separate the hinge from the
rear of the monitor (6).
You can now mount a swivel arm or a
similar accessory in accordance with VESA
FPMPMI using a hole spacing of 100 mm.
For instructions on how to mount the swivel arm or a similar accessory, please
see th e documentation for the swivel arm or similar accessory.
Fujitsu 15
To Next Page
Loading...
