How to fix a Fujitsu B24W-5 ECO Monitor with no screen display?
If your Fujitsu Monitor screen is not displaying anything, first ensure that the ON/OFF switch on the monitor is turned on. Then, check if the power cable is correctly connected to the monitor. Finally, verify that your computer is switched on.
What to do if my Fujitsu Monitor has no screen display but the power indicator is lit?
If your Fujitsu Monitor's power indicator is lit but there's no display, start by checking that the computer is switched on. Next, ensure the monitor's data cable is correctly attached to the monitor port on the computer. Try pressing any key on the keyboard, as the computer might be in power saving mode. As an additional step, adjust the brightness and/or contrast settings until a picture appears.
Why does my Fujitsu B24W-5 ECO say 'No Signal'?
If your Fujitsu Monitor displays a 'No Signal' message, verify that the data cable is correctly attached to the monitor port on your computer. Also, ensure that your computer is powered on.
How to fix a shaking picture on my Fujitsu B24W-5 ECO?
If the picture on your Fujitsu Monitor is shaking, first check that the data cable is correctly attached to the monitor port on the computer. If the issue persists, press the EXIT / AUTO button to perform auto-adjustment of the screen.
What does 'Frequency out of range' mean on my Fujitsu B24W-5 ECO and how to fix it?
If your Fujitsu Monitor displays 'Frequency out of range,' it means the input signal (horizontal frequency and refresh rate) doesn't match the monitor's technical specifications. To resolve this, adjust the video frequency range using your computer's software. Alternatively, set a different screen resolution using the computer software.
How do I resolve picture disturbances (vertical lines) on my Fujitsu B24W-5 ECO?
To address picture disturbances like vertical lines on your Fujitsu Monitor, press the EXIT / AUTO button to perform auto-adjustment of the screen.
How do I get rid of horizontal lines or picture noise on my Fujitsu Monitor?
To eliminate horizontal lines or picture noise on your Fujitsu Monitor, press the EXIT / AUTO button to initiate auto-adjustment of the screen.
How to correct the picture position on a Fujitsu B24W-5 ECO Monitor?
If the picture position on your Fujitsu Monitor is not correct, press the EXIT / AUTO button to perform auto-adjustment of the screen. This is useful when the monitor recognises an undefined mode.
What to do if the picture on my Fujitsu Monitor is wrongly adjusted?
If the picture on your Fujitsu Monitor is wrongly adjusted, press the SELECT / MENU button to activate the Factory Recall function. The Auto Processing message will then appear.
Covers essential safety regulations and precautions for device operation and handling.
Guidelines for using and replacing the supplied power cable, including safety standards.
Procedures for unpacking, checking contents, and verifying delivery.
Steps for physically setting up the monitor and its initial placement.
Detailed steps for connecting data and audio cables to the monitor.
Instructions for connecting cables from the monitor to the computer.
Table of common issues like no display, no signal, and picture distortion with solutions.
Troubleshooting tips for picture disturbances, noise, and a screen that becomes too dark.
To Next Page
General