Getting started
Setting up the device
VideoworkstationErgonomicDevice,
When setting u p your device, please rea d the recommendations and
safety notes in the "Safety/regulations" manual.
We recommend that you place your de vice on a surface with good anti-slip qualities.
In view of the multitude of different finishes and varnishes used on furniture, it is
possible that the rubber feet will m a rk the surface they stand on.
Depending on the location of your device, bothersome vibrations and no ises may
occur. To prevent this, a distance of at least 10 mm / 0.39 in should be maintained
from other devices on casing sides without ventilation surfaces.
In order to avoid overheating, do not cover the ventilation areas
on the monitor or the device.
A minimum distance of 200 mm / 7.87 in from the device must be
observed for ventilation areas.
Do not stack several devices on top of each other.
Do not expose the device to extreme ambient conditions (see "
Technical spe cification",
Page 72, "Ambient conditions"). Protect the device against dust, humidity and heat.
Operating positi
on
You can use the de
vice in a vertical or horizontal operating position.
With the aid of s
uitable feet, it is possible to use the device in a vertical operating position
(see "
Vertical
operating position with feet (optional)", Page 12).
Vertical operating position with feet (optional)
Use the optional feet when you wish to use the device in the vertical operating position.
The set-up direction is compulsory: The ON/OFF switch m ust be at
the top to ensure sufficient ventilation.
You must remove the feet again to be able to open the device.
VerticaloperatingpositionOperatingposition, verticalBasefeetSidecover
Proceed as follows to operate the device in the vertical operating position with the fe et:
► If n ecessary, disconnect the cables connected to the device.
12 Fujitsu
To Next Page
Loading...
Need help?
General