System expansio ns
1
► Slide the drive w ith the EasyChange rails into the bay (1). Check that the component side of
the drive faces downwards towards the base of the casing (with the drive cage closed).
► Connect the cables
at the d rive and at the mainboard. Make sure the polarity is correct.
► Fold the drive cage into the closed position again (see chapter "
Closing the drive cage", Page 44).
► Fit the casing cov
er back on to the casing (see Chapter "
Reattaching the casing cover.", Page 33).
If necessary, y
ou must adjust the entry for the drive accordingly in the BIOS Setup.
Fujitsu 49
To Next Page
Loading...
