Operation
16 Fujitsu Technology Solutions
Power indicator
The power indicator is located on the front of the casing.
1 = Power indicator
● The LED at the ON/OFF switch glows white:
The device is switched on.
● The LED at the ON/OFF switch flashes white:
The device is in sleep mode.
● The LED at the ON/OFF switch does not glow:
– The device is in hibernate mode. After being switched on with the ON/OFF switch, the
device powers up or returns to the state it was in before it entered energy-saving mode.
!
In hibernate or energy-saving mode the device must not be switched off with the
main power switch (if present) or disconnected from the mains, as this may result
in data loss.
or
– The device is switched off (disconnected from the mains) or is ready for use. If the device
is ready it can be enabled with the ON/OFF switch.
To Next Page
Loading...
