Getting started
Fitting the underside cover (device-dependent)
Rating type plate
FUJITSU Deskto p ESPRIMO Q956/Q957:
At the time of device delivery, the bottom cover (2) is not yet mounted on the bottom
of the device, but packed along with the system so that you can read the type rating
plate (3) and the software licence information when preparing it for use.
The type r ating plate and the software licence are affixed on th e device cover and
is usually located below the mounted bottom cover so that it is not visible.
FUJITSU Deskto p ESPRIMO Q55x/Q958:
With the FUJITSU Desktop ESPRIMO Q55x, the type rating plate is attached to the
underside of the device or to the right side of the device (when used vertically).
FUJITSU Desktop ESP
RIMO Q956/Q957:
Only fit the undersi
de cover if you are using the device in a horizontal or
vertical operatin
g position without attaching it to a VESA interface (see
Section "
Setting u
p the device", P age 20).
If you are fitting t
he device onto the VESA interface of a monitor, you
must not fit the und
erside cover. If you d o, the scre w holes for the VESA
attachment will
no longer be accessible.
21 31
Devic
e with device cover (1), with bottom cover
mount
ed (2)
Devic
e with device cover (1) and visible type
plate
(3, ESPRIMO Q956/Q967 only), no bottom
cover
.
The device has a device cover (1) at the bottom. The device cover is divided into two:
during operation, the bottom cover (2) is inserted in the device cover.
In order to be able to mount the botto m cover prior to preparing it for use, proceed as follows:
18 Fujitsu
To Next Page
Loading...
