■
Host Interfaces
A host interface (CA) is an adapter that has interface ports to connect a controller to a server.
Up to two host interfaces for the ETERNUS DX500 S3
and up to four host interfaces for the ETERNUS DX600 S3
can be installed for each controller.
Host interfaces can be added during system operation. When an error occurs, a replacement can be made while
the system is running.
FC, iSCSI, and FCoE are available as the SAN host interface. Ethernet is available as the NAS host interface. Differ-
ent types of interfaces can exist together in the same controller.
The host interface specifications are shown below.
Table 10 Host Interface Specifications
Interface Transfer rate (max.) Connector type Number of ports for each CA
FC 16Gbit/s LC 2 / 4
FC (Long Wave Length type SFP+
module) (*1)
16Gbit/s LC 2 / 4
FC 8Gbit/s LC 2 / 4
iSCSI (with SFP+ module) 10Gbit/s LC 2
iSCSI (without SFP+ module) 10Gbit/s SFP+ (direct attach twinax cop-
per)
2
iSCSI 1Gbit/s RJ-45 2
FCoE (with SFP+ module) 10Gbit/s LC 2
FCoE (without SFP+ module) 10Gbit/s SFP+ (direct attach twinax cop-
per)
2
Ethernet (with SFP+ module) 10Gbit/s LC 2
Ethernet (without SFP+ module) 10Gbit/s SFP+ (direct attach twinax cop-
per)
2
Ethernet 1Gbit/s RJ-45 4
*1: Specifications that apply when a Short wave length type SFP+ module is replaced with a Long wave length
type SFP+ module.
■
Drive Interface Ports
This port is used to connect drive enclosures.
The drive interface port specifications are shown below.
Table 11 Drive Interface Port Specification (Controller)
Interface Transfer rate (max.) Connector type
Number of ports for each controller
ETERNUS DX500 S3 ETERNUS DX600 S3
SAS 12Gbit/s miniSAS HD (SFF-8644) 2 4
6. Hardware Configurations
Controller Enclosure
73
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Hybrid Storage Systems
Overview
Copyright 2019 FUJITSU LIMITED
P3AM-7702-29ENZ0
To Next Page
Loading...
