How to fix READY LED when it is not on Fujitsu Storage?
If the READY LED is not on and more than ten minutes have passed since the Fujitsu Storage system was powered on, contact your maintenance engineer.
Displays the current status of system components and their states.
Procedures for maintaining system health and preventing issues.
Command to degrade a component to a lower state.
Command to force a reboot of a component.
Process for reducing capacity or components without downtime.
Function to identify specific hardware components using LEDs.
Initiates and concludes maintenance operations on the system.
Extends the system by adding a new drive enclosure.
Reduces system capacity by removing a drive enclosure.
Extends system functionality by adding a controller module.
Clears sense data from hosts after component replacement.
Displays the history of events that occurred in the device.
Acquires memory information on failure for analysis.
Shows error frequency for disks and ports.
Exports and saves device maintenance information.
Outputs system composition and setup information.
Gathers grown defect list information from disk management.
Shuts down or restarts the system.
Initializes the system disk.
Manages pinned data not written to disk.
Applies configuration data from an external file.
Changes the master controller module.
Performs diagnostic tests on disk drives.
Explains the meaning of LEDs for maintenance status indication.
Puts the system into maintenance mode for specific operations.
Initiates hot maintenance for component replacement.
Details typical installation times for various system components.
Verifies that component status changes back to normal after replacement.
Collects internal logs as proof of replacement operation.
Returns the system to its normal operational state after maintenance.
Safely logs off from the ETERNUS Web GUI.
Provides detailed technical information for the ETERNUS system.
Offers support-related information for Fujitsu disc storage.
To Next Page
General