Fujitsu ETERNUS DX8100 S3 - Page 18

Safety Precautions
FUJITSU Storage ETERNUS AF, ETERNUS DX Configuration Guide (Power Synchronized Unit)
Copyright 2019 FUJITSU LIMITED P3AM-8012-14ENZ0
18
■ Handling cables
CAUTION
Do
• When installing the power synchronized unit in a rack, be careful not to pinch
your fingers in the rack. Doing so may cause injury.
• Install the blank panels provided with the rack where no other devices are
installed. Failure to do so may cause the power synchronized unit to overheat,
resulting in damage to the device.
• When moving the rack after installing the power synchronized unit, make sure to
contact your sales representative or your maintenance engineer. Do not move the
rack by yourself. Doing so may cause injury and/or damage the power synchro-
nized unit.
CAUTION
Do Not
• Do not damage or modify the cables such as heating, forced bending, twisting,
pulling, or placing heavy objects on them. Doing so may damage the cables and
cause the power synchronized unit to malfunction.
• Do not forcibly bend or fold the cable. Doing so may damage the cable and cause
the power synchronized unit to malfunction.
Do
• Firmly insert cable connectors into inlets, outlets, or sockets. Failure to do so may
cause the power synchronized unit to malfunction.
• When inserting or removing the cable, only hold the connector. Do not hold the
cable. Doing so may damage the cable and cause the power synchronized unit to
malfunction.
• Remove any dirt, dust, oil, grease, etc on cable connectors. Failure to do so may
cause the power synchronized unit to malfunction.
90
Do not bend
more than 90 degrees
Do not fold