Fujitsu ETERNUS LT20 S2 - Setting the LT20 S2;LT40 S2;LT60 S2

Chapter 1 Overview
1.2 References for Setup
FUJITSU Storage ETERNUS LT20 S2/LT40 S2/LT60 S2 Tape Library User’s Guide -Server Connection-
Copyright 2021 FUJITSU LIMITED P3AM-5322-12ENZ0
20
Setting the LT20 S2/LT40 S2/LT60 S2
Perform the settings for the LT20 S2/LT40 S2/LT60 S2.
IMPORTANT
Change the topology setting to "Point to Point" or "Arbitrated Loop". Set fixed values for the link
speed and the Loop ID.
- "Chapter 2 Setting the LT20 S2/LT40 S2/LT60 S2" (page 31)
- "2.2 Settings for Fibre Channel Connections" (page 31)
- "2.2.1 Setting the Link Speed" (page 31)
- "2.2.2 Setting the Topology and the Loop ID (for Direct Host Connections)" (page 32)
Setting the Operating System
Perform the settings for the HBA driver and the device driver.
- "3.1 Solaris OS" (page 35)
- "3.1.2 Fibre Channel Connections" (page 36)
Setting Backup Software
Apply patches, set the robot driver, and set the backup software.
• Backup software used
- NetBackup
• "4.1 NetBackup" (page 47)
- NetWorker
• "4.2 NetWorker" (page 51)
- IBM Spectrum Protect (IBM Tivoli Storage Manager)
• "4.3 IBM Spectrum Protect" (page 53)
Refer
Refer
Refer