Fujitsu ETERNUS LT20 S2 - NetVault Backup 10+ Configuration

Chapter 4 Setting the Backup Software
4.5 NetVault
FUJITSU Storage ETERNUS LT20 S2/LT40 S2/LT60 S2 Tape Library User’s Guide -Server Connection-
Copyright 2021 FUJITSU LIMITED P3AM-5322-12ENZ0
57
- For NetVault Backup 10 and later
To use the cleaning function for NetVault Backup 10 or later, perform the following settings using the
"deviceconfig" command.
Procedure
1 Start the command prompt and change directory to the following location.
<Installation folder for NetVault>\bin
2 Execute the "deviceconfig" command to perform the drive cleaning settings.
The Drive Configuration screen appears.
3 Enter "6" and then press the [Enter] key.
"6) Generic Cleaning..." is selected. The Generic Cleaning screen appears.
If NetVault Backup 11.2 or later is used, the settings can be performed with the WebUI. For details,
refer to "- When WebUI is used with NetVault Backup 11.2 or later" (page 61)
.
deviceconfig.exe –username <user_name_for_NetVault> -password <password>
-drivemachine <NetVault_machine_name_where_the_drive_is_connected>
-drivepath <drive_name_or_path_to_the_drive>