Chapter 4 Setting the Backup Software
4.5 NetVault
FUJITSU Storage ETERNUS LT20 S2/LT40 S2/LT60 S2 Tape Library User’s Guide -Server Connection-
Copyright 2021 FUJITSU LIMITED P3AM-5322-12ENZ0
60
12 Enter "2" and then press the [Enter] key.
"2) Cleaning..." is selected. The Cleaning screen appears.
13 Set the Cleaning items as shown below.
• Automatic Cleaning Supported
ON (the default setting is "ON")
• Barcode Prefix(es) of cleaning media
Set with the character string that is on the label of the cleaning cartridge.
• Cleaning Slots
The slot numbers where the cleaning cartridges are to be stored.
14 Enter "b" and then press the [Enter] key.
The Changer Configuration screen appears again.
15 In the Changer Configuration screen, enter "s" to save the settings.
16 Enter "q" to quit the Drive Configuration screen.
17 In [Manage Devices] of NetVault WebUI, click the [Manage Library] button of the target library
to switch to the Tape Library Management screen.
Reboot the library by clicking the [Restart] button at the lower right.
The new settings are applied after the library is rebooted.
To Next Page
Loading...
