Fujitsu ETERNUS LT60 S2 - Figure 3.39 ETERNUS LT40 S2: Service, Reboot Page

Chapter 3 Operating the Tape Library
3.5 Remote Management Unit (RMU)
FUJITSU Storage ETERNUS LT40 S2/LT60 S2 LTO Library Installing, Starting Up and Maintaining
Copyright 2018 FUJITSU LIMITED P3AM-5392-07ENZ0
69
3.5.8.4 Rebooting the Library
This page is used to perform a library reboot. There is a default time delay when the Web page refreshes itself.
This time should be sufficient to reload the page. However, during a reboot, the connection to the library may
be lost. If the connection is lost, the user will have to reload the page manually.
Figure 3.39 ETERNUS LT40 S2: Service, Reboot page
3.5.8.5 Viewing Library Logs
This page allows the user to view the library logs after entering the following:
• Log Type
• Total Number of Entries
• Start Entry
• Number of Entries per Page
• Update
• Dump Log
• Save Service Dump
• Email Service Dump
Some options of the RMU take the library offline. This inactive mode can interfere with host-based
application software, causing data loss. Ensure that the library is idle before attempting to perform any
remote operations that will take the library offline.