Fujitsu ETERNUS - Page 23

Chapter 2 Setup
> 2.3 Setting Items
ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-
23
Copyright 2009 FUJITSU LIMITED
P2X0-0202-04ENZ0
When the Polling Interval and the Alarm Mailing Interval are different:
(Example) Polling Interval: 300 sec. (5 min.) Alarm Mailing Interval: 1200 sec. (20 min.)
■ Mail Server Address (ETERNUSmgr for Windows® only)
This parameter is used to specify the address of the mail server that will receive the E-mail notifi-
cations from ETERNUSmgr.
E-mail notification is then routed to the specified Admin Mail Address by the mail server specified
here.
[Parameter]
ADMIN_MAILSV
[Example]
When the Mail Server Address is "mailsv.domain-name.com".
ADMIN_MAILSV=mailsv.domain-name.com
■ Mail Server SMTP Port (ETERNUSmgr for Windows® only)
This parameter is used to specify a SMTP port No. for the mail server (ADMINS_MAILSV) when
the ETERNUSmgr server is running on Windows®.
[Parameter]
SMTP_PORT (1-65535)
Unless there is some special reason to change this parameter, it is
recommended to keep the default. For this reason the parameter is initially
commented out.
M
ail contents
S
end mail
G
et
i
nformation
Polling time
1st time
second
time
third time
fourth
time
fifth time
300 sec 1200 sec0 sec 600 sec 900 sec
1st time
second
time
Activate
information
fault 1
detected
fault 2
detected
Activate
information
fault 1
detected
fault 2
detected
• This parameter is initially commented out.
• Normally, the SMTP port is 25. However, if the SMTP port for the
mail server is other than 25 for some reason, correct this parameter
to match.