Fujitsu ETERNUS - Page 3

ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-
3
Copyright 2009 FUJITSU LIMITED
P2X0-0202-04ENZ0
Preface
This guide discusses procedures and safeguards relating to the use of ETERNUSmgr to config-
ure ETERNUS DX400 series, ETERNUS DX8000 series, ETERNUS2000, ETERNUS4000,
ETERNUS8000, ETERNUS3000, ETERNUS6000, or GR series device (hereafter referred to as
a "ETERNUS Disk storage system" or "device"), as well as details of how to conduct mainte
-
nance on, display the status of, and monitor these devices.
This document is specifically written for ETERNUSmgr administrators and operators.
Knowledge of UNIX, Linux or Windows® system administration and Web server administration
are required by this document.
Fourth Edition
October 2009
Structure of this Manual
This guide consists of the following 6 chapters.
• Chapter 1 About ETERNUSmgr
This chapter explains the functions of ETERNUSmgr, its structure, and what other software is
required to operate it.
• Chapter 2 Setup
This chapter explains how to configure ETERNUSmgr and additionally explains how to
monitor multiple machines with ETERNUSmgr.
• Chapter 3 Startup and Shutdown
This chapter discusses how to startup and shutdown ETERNUSmgr.
• Chapter 4 Control Interfaces (Top Menu)
This chapter explains the screens used by ETERNUSmgr.
• Chapter 5 Cautions
This chapter explains important points to keep in mind when using ETERNUSmgr.
• Chapter 6 Messages
This chapter explains the various messages displayed when setting up and using
ETERNUSmgr.