Fujitsu ETERNUS - Page 35

Chapter 2 Setup
> 2.5 Monitoring Multiple Target Devices
ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-
35
Copyright 2009 FUJITSU LIMITED
P2X0-0202-04ENZ0
2.5.2.1 ETERNUSmgr for Solaris OS, HP-UX, AIX, and Linux
When adding extra machines, it is easiest to just copy and edit an existing setup file.
Procedure
1 Confirm the contents of the installation directory.
Make sure that the necessary files and directories (stxchk, _STXPOLL.INI,
STXPOLL_1.INI, stxpoll, stxpolld, www/) have all been installed.
# ls /opt/FJSVgrmgr/
stxchk _STXPOLL.INI STXPOLL_1.INI stxpoll stxpolld www/
2 Copy an existing setup file.
File name starts with "STX" and ends with ".INI".
# cp /opt/FJSVgrmgr/STXPOLL_1.INI /opt/FJSVgrmgr/STXPOLL_2.INI
3 Confirm the copy results.
# ls /opt/FJSVgrmgr/
stxchk _STXPOLL.INI STXPOLL_1.INI STXPOLL_2.INI stxpoll stxpolld
www/
4 Edit the copied file. (The STXPOLL_2.INI file is used here.)
Vi editor is used here.
Refer to "2.3 Setting Items" (page 18) for details of how and which parameters should be
changed in the new setup file.
# vi /opt/FJSVgrmgr/STXPOLL_2.INI
End of procedure
2.5.2.2 ETERNUSmgr for Windows®
When adding extra machines, it is easiest to just copy and edit an existing setup file.
Procedure
1 Confirm the contents of the installation directory using Explorer, etc.
Make sure the following files and folder have been installed in th e installation directory:
_stxpoll.ini, STXPOLL.exe, STXPOLL_1.INI, stxpolld.exe, stxsmail.exe, and \www (\www
is a folder).
No special text editor is required to edit a setup file.
"_STXPOLL.INI" is provided as a model file. If you copy this file to make
a new setup file, be sure to keep the original file as is.