Chapter 6 Messages
> 6.4 Log Messages
ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-
59
Copyright 2009 FUJITSU LIMITED
P2X0-0202-04ENZ0
Can't Get File Status "file name" (CODE 903)
[Explanation]Cannot acquire file status.
[Response] Confirm your access permissions to the file and its directory.
Can't Create Socket (CODE 904)
[Explanation]Failed to create a socket.
[Response] Confirm system resources.
Can't Allocate Memory (CODE 905)
[Explanation]Failed to reserve an open area in memory.
[Response] Allocate the necessary memory.
Bad IP Address "host name or IP address" (CODE 906)
[Explanation]The specified target IP address is invalid.
[Response] Set the correct IP address.
Can't Create Directory "path" (CODE 908)
[Explanation]Failed to create a directory.
[Response] Confirm your access permissions to the directory.
Confirm that the name of the specified directory is correct.
Not NULL Parameter "parameter" (CODE 909)
[Explanation]NULL is not allowed for this parameter setting.
[Response] Set the parameter.
Not Find Parameter "parameter" (CODE 910)
[Explanation]This parameter setting cannot be found.
[Response] Set the parameter.
Parameter too long "parameter" (CODE 911)
[Explanation]Too many characters are used in this parameter setting.
[Response] Correct the parameter setting.
Directory Name too long "directory name" (CODE 912)
[Explanation]The directory name is too long.
[Response] Set a shorter directory name.
Bad Parameter (CODE 913)
[Explanation]The "TARGET_FLAG" parameter is either incorrect or not set.
[Response] Correct the "TARGET_FLAG" parameter.
An example of log message output is shown below.
To Next Page
Loading...
