● 10 - 2
NOTES
*1: The details are described in Chapter5 "ADF DOCUMENT SPECIFICATION".
*2 ) The scanning speeds given are the maximum mechanical scanning speeds. During actual scanning
some extra time will be required for data transfer and software processing.
*3 ) The maximum number will differ due to the paper thickness. Refer to Chapter5 "ADF DOCUMENT
SPECIFICATION".
*4 ) Maximum output resolution may vary according to the scan size, and setting (simplex/duplex)
*5 ) fi-475CMP3 (JPEG compression board) must be installed.
*6 ) USB, SCSI-2 and the Third Party Slot can not be used at the same time.
*7 ) The Power consumption of the boards should be as follows:
- In the Low Power Mode : Less than 0.35 A
1 Scanner Type ADF (Duplex), Document bed
2 Image sensor CCD x 2 Front/Back
3 Light source White Xenon discharge tube x 2 Front/Back
4 Document
Size
Minimum A8 (Portrait)
127g/m
2
Maximum A4/Letter/Legal US Ledger
5 Paper Weight
52 g/m
2
(14 lb) to 127 g/m
2
(34 lb)
Note (*1)
6 Scanning
Speed
Note (*2)
Mono-
chrome
40 pages/min simplex, 80 sides/min duplex 200 dpi
Note (*3)
Color 34 pages/min simplex, 48 sides/min duplex 150 dpi
7 ADF Capacity 100 sheets
A4, 64 g/m
2
(20 lb)
Note (*3)
8 Optical Resolution 600 dpi
9 Output Res-
olution
Note (*4)
Binary 50 - 800 dpi Standard gradient
is 1 dpi, (multiples
are possible)
Grayscale 50 - 600 dpi Standard gradient
is 1 dpi, (multiples
are possible)
Color 50 - 600 dpi Standard gradient
is 1 dpi, (multiples
are possible)
10 Grayscale level (internal) 8 bits per Color Internal 10 bits
11 Halftone Patterns Dither/Error diffusion
12 Other function JPEG compression Note (*5)
13 Interface
Note (*6)
SCSI-2 Shield-type 50 pin
(pin-type) half-
pitch
USB2.0
Third Party Slot Note (*7)
Basic Product Specification
To Next Page
Loading...
